Microprocessor controlled CW Beacon

Dilshan Jayakody
729
0
0
0
This CW beacon module is capable to transmit maximum of 64 Morse codes repeatedly in 4.433MHz with 9V DC power source.
Open in Editor
Known forks (0)
We didn't find the known forks. Make the first fork
Tags
The project owner hasn't added any tags yet.

No License

Published: September 11, 2013 Concept

Project Description

Main Project Image
The project owner hasn't added main project image yet.
Project description
This system consists of CW transmitter, ATtiny13 microcontroller unit and low current voltage regulator. Atmel ATtiny13 microcontroller is used to drive the transmitter and thanks to its internal 64 byte E²PROM, we may be able to change beacon data without altering the system firmware. While at the testing stages we receive this beacon on 10km radius (using Sony ICF-SW7600GR receiver) by using standard telescopic antenna. To get the maximum range it is recommended to use 3m – 4m antenna wire with this transmitter system. At the prototyping /testing stages we try this transmitter successfully with 3.58MHz, 4.43MHz and 6.00MHz crystals. This system is design to work with standard 9V battery (6F22/6LR61). At the prototyping stages we test this system using 12V and 10V DC power sources and get the same results. Transmitter of this system is based on Nyle Steiner’s (K7NS) 80m CW transmitter unit. Online version of project schematic is available at CircuitBee. This project is released as an open hardware project and all the source codes are licensed under the terms of GNU General Public License Version 3 and all the documents, schematics and PCB patterns are licensed under the Creative Commons Attribution-ShareAlike 3.0 license.
Gallery
The project owner hasn't added any images yet.

Design Files

Embed Code
Component (14)
Qty
Description
rcl:R-US_:0207/10

R3, R2, R1

3
rcl:R-US_:0207/10
con-rib:ST2,8:

ST2, ST1

2
con-rib:ST2,8:
linear:78*:Z

IC2

1
linear:78*:Z
rcl:C-US:050-050X075

C3

1
rcl:C-US:050-050X075

Show More

Export Design Data

Open JSON Format
All model data in Upverter's Open JSON export format (more info)
Gerber Format (RS-274X extended)
CAD to CAM transfer instructions (more info)
NC Drill (Excellon)
NC drill and route machine instructions (more info)
XYRS
X-Y, rotation and side data for Pick and Place assembly (CSV)
PADS Layout Netlist
Export your schematic into a third-party layout tool
Dimension Drawing
Export the board outline, holes, and rulers
High-Res Schematic PNG
High resolution image form
3D Model (Step)
3D model of the board and components

Show More